Due to solving those problems :
- Modbus ground connection check.
- VFD frequency regulator loose connection check.
- SPD check .
- RJ-45 connector check.
- Cable check.
- VFD controller Check.
- System Earth Resistance Check etc.
Similar Posts
CCTV Maintenance At DTW-206
1. IP Setup
- ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
IRP-1 sand filter “E” ultrasonic level transmitter installing.
New parameter setting on an old ultrasonic level transmitter and installing complete. now sand filter “E” is normal. SCADA value & field value…
DTW-122 Grass plantation
There is so much dust so we Plant grass to prevent road side dust
- ACTIVITY | DAILY REPORTS | DTW | Pappu | Parvez
Dtw-122 serial Comm.New UTP Cable installing complete.
Problem: : Modbus com interrupt problem.Problem found:The serial communication cable was cut by rat 🐁. then UTP Cable installing . new pump is…
- ACTIVITY | DAILY REPORTS | Jewel | Pappu | Pending Issue
IRP1 Sludge drying bed float switch checking.
Problem found: Sludge bed চেম্বারে কাদার পরিমান বেশি হওয়ার কারনে ৷ LoLo সিগনালের ফ্লোট সুইচটি কাদার মধ্যে অাটকে যাচ্ছে ৷তাই স্কাডাতে HiHiLoLo সিগনাল…
