DTW#106,117,118 AND 223 PTT AND UVR CHECKING COMPLETE
106,117,118 এবং 223 এই DTW গুলো তে আগে পাওয়ার চলে গেলে ফল্ট ধরে রাখত যার কারণে অপরেশন টিম থেকে লোক পাঠিয়ে এটা রিসেট…
-
-
ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
IRP#1 SLUDGE DRYING BED FAULT SHOWING PROBLEM CHECKING
ফ্লোট সুইচ কাদার সাথে আটকে যাওয়ার কারণে লো-লো কন্ডিশন দেখায়। পরে এই সমস্যা আমরা আইডেন্টিফাইড করে সমাধান করে দিয়েছি। বর্তমানে ঠিক আছে।
-
-
-
ACTIVITY | DAILY REPORTS | DTW | Jewel | Pappu | Parvez | Pending Issue
DTW-117 & 118 UVR Related M/C checking.
Problem: after power up time ACB do not close from the SCADA command. Problem found: 27X Magnetic Contact (M/C) & AUX Contact Unit…
-
ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez | Pending Issue
OGR Booster pump E checking & maintenance.
Problem: OGR Booster pump E running time Moter current high (682 Amp) showing than pump stop that time frequency is 0.3 Hz (Abnormal).Problem…
-
DTW-201 CCTV checking
Problem: Do not show footage in NAV.Problem found: ONU & 1 Nos cc camera Problem found.
-
ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
4 nos Monitoring Well Level Sensor Installation Complete.
1 :MW03B 2: MW14A 3:MW08A 4: MW13B
-
ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
OGR booster pump D winding temperature & Bearing temperature sensor checking.
Problem: In those sensors, high temperature shows in transmitter display. But when we check the mA current of sensor signal, that was OK….
-
ACTIVITY | DAILY REPORTS | Pappu | Parvez
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Problem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
