1.VFD Controller Installation
2.Modbus Serial Communication Cable Check
Similar Posts
ACTIVITY | DAILY REPORTS | DTW | Pappu | Pending Issue
UVR checking complete at DTW 216
Problem: Shutdown time is ACB not open.Problem found: ACB Internal control unit not working found.Observation: DTW 216 UVR checked, when plug PTT UVR…
DTW-123 Inverter Fault and VFD do not Power Up
1.VFD Controller Damage 2. Emergency Switch control Open circuit Fault Found. Now we change a VFD Controller and Maintenance the control circuit Now…
ACTIVITY | DAILY REPORTS | Pappu | Parvez
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Problem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
ACTIVITY | CCTV | DAILY REPORTS | DTW | REPORTS
CCTV Maintenance At DTW-101
1.1Nos New Camera Installation 2. UTP Cable Change 3. Connector Change 4. IP setup
