Similar Posts
- ACTIVITY | DAILY REPORTS | Pappu | Parvez
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Problem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
- ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
OGR booster pump D winding temperature & Bearing temperature sensor checking.
Problem: In those sensors, high temperature shows in transmitter display. But when we check the mA current of sensor signal, that was OK….
- ACTIVITY | DAILY REPORTS | DTW | Jewel | Parvez
PIT maintenance work report (IRP-2)
PIT maintenance work reportDtw-213 maintenance. Now okDtw-208 maintenanceNow okDtw-207 maintenanceNow okDtw-211 PIT damagedDtw-203 PIT doesn’t exist.Dtw-205 PIT damagedDtw-206 SCADA PACK doesn’t exist
- ACTIVITY | CCTV | DAILY REPORTS | DTW | REPORTS
CCTV Maintenance At DTW-105
2 Nos New Camera Installation . 2. new 20m utp cable install 3. connector change 4. IP Setup
- ACTIVITY | DAILY REPORTS | DTW | Jewel | Pappu | Parvez | Pending Issue
DTW-117 & 118 UVR Related M/C checking.
Problem: after power up time ACB do not close from the SCADA command. Problem found: 27X Magnetic Contact (M/C) & AUX Contact Unit…
