when we install new VFD controller , the HMI Graph do not change from scada that time . so we reinstall old VFD controller again. now this DTW in normal Operation.
Similar Posts
ACTIVITY | DAILY REPORTS | Pappu | Parvez
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Problem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
IRP-1 backwash holding tank (2P01A) pump Checking & Problem Found.
problem found: IRP-1 Backwash holding tank -A pump’s cable terminal box gets short circuit & burn. For instance, a fault signal came in…
ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
IRP-1 sand filter “E” ultrasonic level transmitter installing.
New parameter setting on an old ultrasonic level transmitter and installing complete. now sand filter “E” is normal. SCADA value & field value…