Problem: SCADA always showing HI signal.
Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with HI position. Now there are three positions available LoLo, Lo & HI.
Similar Posts
DTW-120 CCTV Maintenance
DTW-120 CCTV Maintenance There was connector Problem. Now DTW-120 (5 nos ) camera operation in NAV-2
- ACTIVITY | CCTV | DAILY REPORTS | DTW | Parvez
IRP-2 Sub-Station CC Camera Maintenance
IRP- 2 1nos CC Camera Maintenance done, there was connector problem. now IRP-2 Sub-Station all CC Camera in operation.
- ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
Chlorine cylinder lode shell checking and maintenance.
Problem found: lode shell connection terminal circuit problem found.
One Comment