Problem: SCADA always showing HI signal.
Problem found: 1 Nos float switch problem. HI signal float switch problem & float switch connection terminal problem found.
Similar Posts
DTW-202 CCTV Maintenance
1.one new camera installation 2. Connector Change 3.IP Setup
ACTIVITY | DAILY REPORTS | MOV | Pappu | Parvez
IRP-2 3V07A MOV Reset, reprogramming and configuration work complete.
Problem: This MOV is abnormal working. MOV Open time & close time 0% to 100% value not showing. IRP-2 3V07A MOV Reset, reprogramming…
IRP-1 and IRP-2 Sludge Drying Bed LOP Control Cable Change
Previous control cable is damaged by ant .so we replace new control cable
One Comment