Findings: UVR being under voltage, it need a reset to execute Close Command.
Action: ACB open/close command relay check. Isolate the physical reset cable from MC.
Similar Posts
ACTIVITY | DAILY REPORTS | Jewel | Parvez | REPORTS
IRP-2 Sub-Station Re cleaning
There was so much dust
ACTIVITY | DAILY REPORTS | Pappu | Parvez
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Problem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
DTW#217,216,209 VFD RTU AND CCTV PANEL CLEANING
DTW#217,216,209 VFD RTU AND CCTV PANEL CLEANING COMPLETE There was so much dust
DTW-122 Grass plantation
There is so much dust so we Plant grass to prevent road side dust
IRP-2 Server Rak Installation
IRP-2 Sub-Station 1Nos New Server Rack Installation Done