ScadaPack transfer from DTW-207 to 202 Done
Similar Posts
- ACTIVITY | DAILY REPORTS | Pappu | Parvez
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Problem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
DTW-109 Radio communication check by new Antenna installing
Due to facing lots of obstacles in front of line of sight, the radio signal is too much worst
- ACTIVITY | CCTV | DAILY REPORTS | DTW | Parvez
IRP-2 Sub-Station CC Camera Maintenance
IRP- 2 1nos CC Camera Maintenance done, there was connector problem. now IRP-2 Sub-Station all CC Camera in operation.
- ACTIVITY | CCTV | DAILY REPORTS | DTW | REPORTS
CCTV Maintenance At DTW-105
2 Nos New Camera Installation . 2. new 20m utp cable install 3. connector change 4. IP Setup
- ACTIVITY | DAILY REPORTS | DTW | Pappu | Pending Issue
DTW- 113 UVR & UVR Related M/C checking complete.
Problem: after power up time ACB do not close from the SCADA command.Problem found: 27X M/C Magnetic Contact & AUX CONTACT UNIT Problem…
