1.1Nos New Camera Installation 2. UTP Cable Change 3. Connector Change 4. IP setup




1.1Nos New Camera Installation 2. UTP Cable Change 3. Connector Change 4. IP setup




IRP-1 All sandfilter ultrasonic sensor cleaning Done. There was so much dust
VFD modbus interrupt problem found. Than reset the VFD.
Device Status OLT : OK UPS: OK ONU: Ok POE Switch : OK Findings: Too much dust inside all device. Suggestion: New separate…
IRP-1 SDB Additional Dewatering Pump check: 1. Motor winding Resistance check (Normal) 2. Motor Ampere check (Normal) 3. MC coil check ( little…
One Comment