IRP-1 All sandfilter ultrasonic sensor cleaning Done.
There was so much dust
Similar Posts
- ACTIVITY | DAILY REPORTS | MOV | Pappu | Parvez
IRP-2 3V07A MOV Reset, reprogramming and configuration work complete.
Problem: This MOV is abnormal working. MOV Open time & close time 0% to 100% value not showing. IRP-2 3V07A MOV Reset, reprogramming…
- ACTIVITY | DAILY REPORTS | Pappu | Parvez
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Problem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
PIT Installation
DTW-205 1Nos New PIT Installation Done DTW-211 1Nos New PIT Installation Done DTW-104 1Nos Old PIT Installation Done
- ACTIVITY | DAILY REPORTS | Jewel | Pappu | Parvez
IRP-1 sand filter “E” ultrasonic level transmitter installing.
New parameter setting on an old ultrasonic level transmitter and installing complete. now sand filter “E” is normal. SCADA value & field value…
