







Problem: after power up time ACB do not close from the SCADA command.Problem found: DTW 114 UVR its burn inside circuit . UVR…
1.DTW-114 1Nos Camera Install Done 2.New UTP Cable Install 3.Connector Change Now DTW-114 5Nos Camera in Operation
DTW-114 PIT ok. DTW-113 PIT ok but scadapack AO port damaged. DTW-104 PIT doesn’t exist. DTW-105 PIT ok (regeneration on going)
1.UTP Cable Change 2.Connector Change 3.IP Setup
1. connector change 2. IP Setup
when we install new VFD controller , the HMI Graph do not change from scada that time . so we reinstall old VFD…