Finding: MOV 2V07-L opening & closing time percentage isn’t showing properly in SCADA & Field side.
Action Taken: Reset the MOV-2V07.
Similar Posts
Preventive working schedule-Nov2023( Md. Parvas)
Posted onSL. No. Date WID: TaskDescription Location Manpower Remarks 2 November PWID60: DTW-101 RTU, LIT, PIT, FIT clean check & maintenance. DTW-101 Parvas-AT Ahsanullah-Ele…
- ACTIVITY | CCTV | DTW | NETWORK CONNECTIVITY
A new ONU install at DTW-201.
Posted onPrevious ONU frequently becomes unstable/hang. So replace the ONU.
- ACTIVITY | CCTV | DAILY REPORTS | DTW
DTW-114 CC Camera Install
Posted on1.DTW-114 1Nos Camera Install Done 2.New UTP Cable Install 3.Connector Change Now DTW-114 5Nos Camera in Operation
IRP-1 All sandfilter ultrasonic sensor cleaning
Posted onIRP-1 All sandfilter ultrasonic sensor cleaning Done. There was so much dust
DTW-115 VFD fault problem maintenance.
Posted onVFD modbus interrupt problem found. Than reset the VFD.
WID616: DTW-107 LIT, PIT, FIT isolation due to regeneration work.
Posted onDue to regeneration work, We disconnect the connection of LIT, PIT, FIT.