WID562:DTW217 flow value is not shown in SCADA

Findings: The cable was disconnected.

Action taken: Dressing the cable and reconnect.

WID601: FIT4002 value is fluctuating too much… which is unusual… need urgent checking.

Posted onDecember 14, 2023December 14, 2023

Findings: FIT-4002 Ultrasonic sensor Schedule maintenance time over ., Action taken: Plug out both Upstream & Downstream sensor. Clean the sensor & cable…

REPORTS

Report: IRP-2 Sub-station CCTV Server Panel Preventive Maintenance.

Posted onJuly 5, 2022July 5, 2022

Device Status OLT : OK UPS: OK ONU: Ok POE Switch : OK Findings: Too much dust inside all device. Suggestion: New separate…

ACTIVITY | DAILY REPORTS | DTW | Pappu

DTW-122 PIT Fuse and Serial communication cable check and maintenance complete.

Posted onOctober 24, 2022October 24, 2022

DTW-122 PIT Fuse and Serial communication cable check and maintenance complete.Problem: PIT value not showing in the SCADA.Problem found: 1. PIT 24v DC…

Uncategorized

DTWs as on Locally Operational

Posted onDecember 26, 2022December 27, 2022

DTW101 Problem: Dtw-101 Sometimes the pump stops suddenly. This has happened time and time again. There is no fault in SCADA. Field check…

Uncategorized

WID-243: (NEW)DTW-116 communication fully error

Posted onApril 8, 2023April 8, 2023

DTW-116 communication fully error Location: IRP1 Problem Start Date: 6/4/2023 Identified By: Ruhul Amin Solve at: Total Time Required: Total Manpower Deployed: Lead…

ACTIVITY | DAILY REPORTS | DTW | Pappu | REPORTS

DTW-109 Radio Communication Check

Posted onNovember 14, 2022November 14, 2022

The signal strength so week and we can’t develope the signal strength changing in Multiple direction. there is not clear line of sight…

2 Comments

MD ZAHID HOSSAIN says:

November 15, 2023 at 4:07 pm

How the cable was disconnected?

Reply
1. PARVEZ HOSSAIN says:
  
  December 4, 2023 at 3:34 pm
  
  There isn’t the terminal box placed properly. & the cable was so thin. Need to change the terminal box.
  
  Reply

WID562:DTW217 flow value is not shown in SCADA

WID601: FIT4002 value is fluctuating too much… which is unusual… need urgent checking.

Report: IRP-2 Sub-station CCTV Server Panel Preventive Maintenance.

DTW-122 PIT Fuse and Serial communication cable check and maintenance complete.

DTWs as on Locally Operational

WID-243: (NEW)DTW-116 communication fully error

DTW-109 Radio Communication Check

2 Comments

Leave a Reply to MD ZAHID HOSSAIN Cancel reply

Join With Us

Similar Posts

2 Comments

Leave a Reply to MD ZAHID HOSSAIN Cancel reply

Join With Us