Problem: SCADA always showing HI signal.
Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with HI position. Now there are three positions available LoLo, Lo & HI.
Similar Posts
- ACTIVITY | CCTV | DAILY REPORTS | DTW
DTW#105 CCTV Checking Maintenance Complete.
Posted onProblem: Do not show footage in NAV.Problem found: Optical Network Unit (ONU) problem & 2 nos cc camera damage found and New ONU installing. Now…
OGR Booster room dewatering pump run command showing problem at low level
Posted onFloat switch reconnection and rearrange. Now normal
- ACTIVITY | CCTV | DAILY REPORTS | DTW | REPORTS
CCTV modification work for Dual power source
Posted onCCTV modification work for Dual power source Done Now CCTV continuous View remain All time.
IRP1 Sludge drying bed float switch checking.
Posted onProblem found: Sludge bed চেম্বারে কাদার পরিমান বেশি হওয়ার কারনে ৷ LoLo সিগনালের ফ্লোট সুইচটি কাদার মধ্যে অাটকে যাচ্ছে ৷তাই স্কাডাতে HiHiLoLo সিগনাল…