Problem: In those sensors, high temperature shows in transmitter display. But when we check the mA current of sensor signal, that was OK. Now we will have to change the transmitter .
Similar Posts
DTW-103 VFD Controller Install
Posted on1.DTW-103 New VFD Controller Install 2. Parameter set 3.Serial Communication Cable Wiring Work Done
VFD Report 2022
Posted onVFD Report November 2022 SL NO. DTW NO. Controller Status VFD Status Serial Communication Remarks 01 101 OK OK ✅OK 02 102 OK…
- ACTIVITY | DAILY REPORTS | DTW | REPORTS
DTW-211 CCTV power is taken from main ups
Posted onDTW-211 CCTV power is taken from main ups. Do not get sufficient backup from ups and frequently fault occurs.
- ACTIVITY | DAILY REPORTS | DTW
PIT Maintenance Work Report (IRP-1)
Posted onDTW-114 PIT ok. DTW-113 PIT ok but scadapack AO port damaged. DTW-104 PIT doesn’t exist. DTW-105 PIT ok (regeneration on going)
Radio communication checking complete DTW 221.
Posted onObservation: Radio communication checking complete DTW 221.1. In DTW 221, We checked up to 10 minutes. RSSI Value (Dc volts) MAX: 2.700V, MIN:…
- ACTIVITY | DAILY REPORTS | DTW
Dtw-122 serial Comm.New UTP Cable installing complete.
Posted onProblem: : Modbus com interrupt problem.Problem found:The serial communication cable was cut by rat 🐁. then UTP Cable installing . new pump is…