Problem: SCADA always showing HI signal.
Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with HI position. Now there are three positions available LoLo, Lo & HI.
Similar Posts
- ACTIVITY | DAILY REPORTS | DTW | REPORTS
FIT Maintenance Work Report (IRP-1)
Posted onপ্ল্যান্ট শুরুর পর হতে অদ্যাবধি ফ্লো-মিটারের মেইন্টেনেন্স কাজ করা হয়নি। মেক্যানিক্যাল ফ্লো-মিটার হওয়ার কারনে যদি ও ঠিকমত রিডিং পাওয়া যায়না, তদুপরি প্রাপ্ত পালসের…
DTW-219 & 220 Cleaning
Posted onDtw-220 & 219 RTU, VFD & CCTV Panel all equipment cleaning
DTW-122 Modbus Interrupt problem maintenance
Posted onThe modbus serial communication cable is cut by mouse. The cable reconnect & solve the problem.
- ACTIVITY | DAILY REPORTS | DTW
DTW-110 Pump inspection & ready to run up.
Posted onProblem Found: 1. VFD (-) Hz showing 2. Non-return Valve damaged. 3. Reverse water flow. 4. The pump acts as a generator due…
DTW-211 Serial Communication Cable check and Rejoin
Posted onDTW-211 Serial Communication Cable check and Rejoin Done. Now communication normal
- ACTIVITY | CCTV | DAILY REPORTS | DTW
DTW#201 CCTV Checking Maintenance Complete.
Posted onProblem: Do not show footage in NAV.Problem found: POE Switch problem & 1 nos cc camera damage found and New POE Switch installing. Now problem…