problem found: IRP-1 Backwash holding tank -A pump’s cable terminal box gets short circuit & burn. For instance, a fault signal came in SCADA. pump coil is ok. LOP controlling cable condition is very bad.
Similar Posts
DTW-109 Radio communication check by new Antenna installing
Posted onDue to facing lots of obstacles in front of line of sight, the radio signal is too much worst
- ACTIVITY | DAILY REPORTS | DTW | REPORTS
IRP-1 and IRP-2 Sludge Drying Bed LOP Control Cable Change
Posted onPrevious control cable is damaged by ant .so we replace new control cable
DTW-117 & 118 UVR Related M/C checking.
Posted onProblem: after power up time ACB do not close from the SCADA command. Problem found: 27X Magnetic Contact (M/C) & AUX Contact Unit…
- ACTIVITY | DAILY REPORTS | DTW
PIT Maintenance Work Report (IRP-1)
Posted onDTW-114 PIT ok. DTW-113 PIT ok but scadapack AO port damaged. DTW-104 PIT doesn’t exist. DTW-105 PIT ok (regeneration on going)