1.Cable connector change 2. IP Setup
Similar Posts
OGR booster pump D winding temperature & Bearing temperature sensor checking.
Posted onProblem: In those sensors, high temperature shows in transmitter display. But when we check the mA current of sensor signal, that was OK….
WID568: IRP-01 Sand filter MOV-2V07L MOV Opening and closing time Percent value not showing … During the Opening period Directly 0 to 100% showing. Need to check.
Posted onFinding: MOV 2V07-L opening & closing time percentage isn’t showing properly in SCADA & Field side. Action Taken: Reset the MOV-2V07.
Chlorine cylinder lode shell checking and maintenance.
Posted onProblem found: lode shell connection terminal circuit problem found.
4 nos Monitoring Well Level Sensor Installation Complete.
Posted on1 :MW03B 2: MW14A 3:MW08A 4: MW13B
CCTV Maintenance At DTW-206
Posted on1.Cable connector change 2. IP Setup