1.Cable connector change 2. IP Setup
Similar Posts
IRP#2 Sludge drying bed A float switch checking complete.
Posted onProblem: SCADA always showing HI signal. Problem found: 1 Nos float switch problem. HI signal float switch problem & float switch connection terminal…
- ACTIVITY | DAILY REPORTS | DTW | REPORTS
DTW-122 Grass plantation
Posted onThere is so much dust so we Plant grass to prevent road side dust
DTW- 201 Radio Communication checking complete.
Posted onObservation: DTW 201 Radio Communication checking complete. This DTWs communication is very bad.1. In DTW 201, We checked up to 10 minutes. In…
- ACTIVITY | DAILY REPORTS | DTW | REPORTS
DTW-123 Inverter Fault and VFD do not Power Up
Posted on1.VFD Controller Damage 2. Emergency Switch control Open circuit Fault Found. Now we change a VFD Controller and Maintenance the control circuit Now…
IRP-1 CCTV monitor HDMI cable plug & power up
Posted onIRP-1 CCTV monitor HDMI cable plug & power up Done
- ACTIVITY | DAILY REPORTS | MOV
IRP-2 3V07A MOV Reset, reprogramming and configuration work complete.
Posted onProblem: This MOV is abnormal working. MOV Open time & close time 0% to 100% value not showing. IRP-2 3V07A MOV Reset, reprogramming…