Similar Posts
DTW- 114 UVR & UVR Related M/C checking complete.
Posted onProblem: after power up time ACB do not close from the SCADA command.Problem found: DTW 114 UVR its burn inside circuit . UVR…
WID568: IRP-01 Sand filter MOV-2V07L MOV Opening and closing time Percent value not showing … During the Opening period Directly 0 to 100% showing. Need to check.
Posted onFinding: MOV 2V07-L opening & closing time percentage isn’t showing properly in SCADA & Field side. Action Taken: Reset the MOV-2V07.
OGR Booster room dewatering pump run command showing problem at low level
Posted onFloat switch reconnection and rearrange. Now normal
- ACTIVITY | DAILY REPORTS | DTW
PIT Maintenance Work Report (IRP-1)
Posted onDTW-114 PIT ok. DTW-113 PIT ok but scadapack AO port damaged. DTW-104 PIT doesn’t exist. DTW-105 PIT ok (regeneration on going)
DTW-218 UPS Output Voltage Showing High.
Posted onNew UPS installed at DTW-218 and old UPS brought to plant for problem checking. Now the pump is running and everything is normal.
IRP#2 Sludge drying bed A float switch checking complete.
Posted onProblem: SCADA always showing HI signal. Problem found: 1 Nos float switch problem. HI signal float switch problem & float switch connection terminal…