Problem: PIT value does not showing in the SCADA & field device.
Problem found: PIT 24v AC supply fuse damage found & maintenance. now PIT is ok.
Similar Posts
- ACTIVITY | DAILY REPORTS | MOV
OGR Booster pump (E) checking complete.
Posted onProblem: When the pump is stopped and normally shuts off, a fault automatically occurs in the MOV (4P01-E). In this case the valve…
Optical Fiber Network Report 2022
Posted onOptical Fiber Network Status October 2022 SL NO. Location In Between DTW Near Pole No Lat/Long Affected Location Remarks 01 Baherchor to Bottoli…
SCADA PACK REPORT IRP 1/2
Posted onSI DTW STATUS COMMENT 1 101 OK 2 102 OK 3 103 OK 4 104 OK 5 105 OK 6 106 OK 7…
CCTV Maintenance At DTW-209
Posted on1.Cable connector change 2. IP Setup
IRP#2 Sludge drying bed A float switch checking complete.
Posted onProblem: SCADA always showing HI signal. Problem found: 1 Nos float switch problem. HI signal float switch problem & float switch connection terminal…
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Posted onProblem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…