Problem: SCADA always showing HI signal.
Problem found: 1 Nos float switch problem. HI signal float switch problem & float switch connection terminal problem found.
Similar Posts
IRP-1 sand filter “E” ultrasonic level transmitter installing.
Posted onNew parameter setting on an old ultrasonic level transmitter and installing complete. now sand filter “E” is normal. SCADA value & field value…
- ACTIVITY | CCTV | DAILY REPORTS | DTW
IRP-2 Sub-Station CC Camera Maintenance
Posted onIRP- 2 1nos CC Camera Maintenance done, there was connector problem. now IRP-2 Sub-Station all CC Camera in operation.
- ACTIVITY | CCTV | DAILY REPORTS | DTW | REPORTS
DTW-212 & 222 CCTV Maintenance
Posted onDTW-212 & 222 CCTV Maintenance Done Connector Change Now DTW-212 & 222 10 No’s CCTV Operation in NAV
- ACTIVITY | CCTV | DAILY REPORTS | DTW | REPORTS
DTW- 208 Fault Come in CCTV UPS
Posted onDtw-208 CCTV power supply is received from directly LV panel. Frequently Fault come in UPS. Now Everything is Normal.
- ACTIVITY | DAILY REPORTS | DTW | REPORTS
DTW-123 Inverter Fault and VFD do not Power Up
Posted on1.VFD Controller Damage 2. Emergency Switch control Open circuit Fault Found. Now we change a VFD Controller and Maintenance the control circuit Now…