Similar Posts
A new PoE switch install at DTW-201
Posted onPrevious PoE switch has port problem.
WID577: DTW-204 ACB can not close from SCADA.
Posted onFindings: UVR being under voltage, it need a reset to execute Close Command. Action: ACB open/close command relay check. Isolate the physical reset…
CCTV Maintenance At DTW-107
Posted on1. connector change 2. IP Setup
IRP-2 Sludge Drying Bed Pump-A Float Type Level Sensor Maintenance
Posted onProblem: SCADA always showing HI signal. Problem found: 1 NOS float switch problem found. A good sensor in HIHI position is replaced with…
DTW205 Modbus Communication Interrupt-Inverter Fault
Posted onProblem DTW205 তে হঠাৎ বিএফডি ফল্ট এসে পাম্প বন্ধ হয়ে যায়। ফিজিক্যালি চেক করে এই সমস্যাটি পাওয়া যায়। ফল্ট রিসেট করে পাম্প রান…
- ACTIVITY | DAILY REPORTS | MOV
OGR Booster pump (E) checking complete.
Posted onProblem: When the pump is stopped and normally shuts off, a fault automatically occurs in the MOV (4P01-E). In this case the valve…